discount 70% in 2018-09-20 to 2018-09-22
price: USD$ 378.00
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler
TDGC2Single phase contact voltage regulator
TDGC2Series regulators are new energy saving products made of imported silicon steel sheets. This regulator pressesJB/T10091Design, manufacture and inspection of relevant standards.
■ Product features
This series of products has the following characteristics:
The output voltage can be regulated continuously0—250VIt has the characteristics of no distortion, small size, light weight, high efficiency, convenient operation, reliable performance, long term operation, etc..
■Range of use
This series of voltage regulators can be widely used in industry(Such as chemical, metallurgical, instrument and meter, mechanical and electrical manufacturing, light industry, etc.)In scientific experiments, public equipment and household appliances, it is an ideal AC voltage regulator for the purpose of regulating voltage, controlling temperature, regulating speed, adjusting light and power control.
Rated input voltage rangeV）
Output voltage rangeV）
0～250 0～300 0～350 0～400 0～430 0～450 0～500
■Specifications and mounting dimensions
Rated output currentA）
TDGC2Series single-phase voltage regulator
■ Installation, use and maintenance
1The power supply voltage shall conform to the input voltage on the nameplate of the regulator;
2The voltage regulator must be grounded properly to ensure safety;
3The output current should not exceed the rated value, otherwise the life of the regulator will be reduced or even burned down;
4When using, the handwheel should be rotated slowly and evenly, so as not to cause the brush damage or spark;
5It is necessary to check the use of the regulator frequently, such as excessive wear of the brush, defect, timely change of the same specifications of the brush, and zero sandpaper pad under the brush rotating handwheel several times, so that brush bottom surface grinding, good contact, you can use;
6Coil and brush contact surface should always be clean, otherwise easy to increase the spark and burn the coil surface. If the surface of the coil is burnt with black spots, it can be wiped with cotton alcohol until the surface spots are removed;
7From the power supply to the regulator, the voltage regulator connected to the load wire and wire terminals should be in good contact and can pass the voltage regulator rated current;
8When the regulator is moved, the handwheel can not be used, or the handle is lifted or the whole product is moved;
9And you need to cross the regulator panel or stand mounted on the base can be used in other adjustable mounting hole pressure device base to be fixed;
10The regulator often protects the clean water and does not allow water drops to fall into the regulator. The regulator must regularly cut off the dust accumulated inside the regulator;
■Precautions for use
This series of voltage regulators should be used indoors, and the normal operating conditions are as follows:
1,Ambient temperature: -15℃～＋45℃；
2,Altitude not exceeding1000m；
4,Power voltage waveform: the voltage waveform of the power supply is approximately sinusoidal;
5,The installation site shall have no serious influence on the gas, steam, chemical deposition, dust, dirt and other explosive and corrosive medium of the insulation of the regulator, and there shall be no serious vibration or jolt in the installation site;
7,No parallel use,Otherwise it will burn out the voltage regulator.
More detailed information please consult; our company engineering and technical personnel will be happy to serve you, should product technology innovation.