Connect with us

Jin Mei Si rubber insulation glue glue rubber board glue adhesive sticky iron wind pipe insulation materials

The above price is a barrel unit price, a barrel of 9 kg (including the weight of the bucket) need the pro contact online customer service.

discount 70% in 2018-10-17 to 2018-10-19
price: USD$ 77.00
freight :USD$18.00,(Express)
freight :USD$7.00,(Postal parcel)
Search Similar or mail to saler or send message to saler

Pay with PayPal, PayPal Credit or any major credit card

Name: Jin Mei Si rubber insulation adhesive glue

Specifications: the price is a barrel unit price, a barrel of 9 kg (including the weight of the bucket) need the pro contact online customer service.

Correct use of rubber and plastics glue:

1, before use to shake the container so that the glue evenly, then the actual installation, use small bottles of glue, to prevent the volatilization of too fast, if necessary, can be used in the tank into the pot, not the jar seal.

2. Use a short and hard brush.

3, the bonding surface at both ends of the material is coated with a thin layer of uniform special glue.

4. The natural drying time of special glue is 3 - 10 minutes, the length of time depends on the grade of glue, the temperature and humidity of the atmosphere, and the exposure time is invalid for more than 20 minutes.

5, the use of glue to dry naturally, the correct drying method is "finger touch method", with finger contact surface, if the finger will not stick to the surface of the material, and the surface of the material has no sticky hand feeling, you can bond.

6, bonding, only the sticky interface two surface alignment grip for a moment.

7, if the placement time is too long, so that the two faces are pressed together without viscosity, then repeat steps 2 - 6.

8, usually, every kilogram of rubber and plastic special glue can daub two square meters adhesive surface.

9, usually, special glue can not be used under 5 degrees Celsius, when working in the environment of 5 - 10 degrees Celsius, please put glue at room temperature of 20 degrees, and need to take out.

10, when connecting two materials under pressure, do not have to wait until the glue is dry, wet bonding method, the materials are placed in the installation area, at the material interface glue, adjust the two material in the right position and position of the glue soon according to your design firm.

11. Check whether the adhesive between the glue and the protecting iron pipe is firm and firm.